Subversion Repositories configs

# the ST400 is fixed to ID 3

scsi SIEMENS "ST 400" Scanner * * 3 *

scsi SIEMENS "ST 800" Scanner * * 3 *

# The following options are for testing and bug-hunting.  If your scanner

# needs one of these options to function reliably, please let me know.

# Maximum amount of data to read in a single SCSI command.  If not set

# (or set to 0), the backend will read as much data as allowed by the

# scanner model or the OS.  WARNING: Using this option overrides the

# hardcoded # maxread limits for all scanner models!  With more than

# 65536 bytes, my ST400 locks up (itself, the SCSI bus, the sg driver,

# and the machine). Use with caution.

#option maxread 65536

# Use this to switch the scanner lights on with a separate MODE SELECT call

# and wait for some time before starting to scan (to allow the lights to go

# to full intensity).  The time is in 1/10 seconds (i.e. 20 means 2 seconds).

# If not set, scanning starts immediately (works with my ST400).

#option delay 20

# The following are hacks that affect all scanners of the same model as the

# last attached device.  Used like this (assume ST800's had 8bit depth and

# 4MB internal buffer):

#   scsi SIEMENS "ST 400" Scanner * * 3 *

#   option scanner_bufsize 2097152

#   option scanner_bits 6

#   scsi SIEMENS "ST 800" Scanner * * 3 *

#   option scanner_bufsize 4194304

#   option scanner_bits 8

# Currently, the backend has entries for ST400, ST800 and "everything else".

# To add more scanners, you have to add a line in the st400_models array.

# Please note that these options are only for testing unknown devices with

# this backend.

# Internal scanner buffer:

#option scanner_bufsize 2097152

# Bit depth:

#option scanner_bits 6

# Maximum bytes to read in a single SCSI command (see also maxread above).

#option scanner_maxread 65536

# Supported resolutions (upto 15 different values).  If you specify an

# illegal value here, most likely the scanner will not report an error,

# but only scan a small sub-area of the requested area (at least my ST400

# does this).

#option scanner_resolutions 200 300 400

# This option causes the SCSI inquiry response to be written to

# "$HOME/st400.dump" (as binary data).  For debugging purposes.

#option dump_inquiry